Huawei Quidway S3000-EI Series, Руководство по эксплуатации

Страница: 63 / 392

Operation Manual - Port
Quidway S3000-EI Series Ethernet Switches
Chapter 2 Link Aggregation Configuration
Huawei Technologies Proprietary
2-1
Chapter 2 Link Aggregation Configuration
2.1 Link Aggregation Overview
The link aggregation means aggregating several ports together to implement the
outgoing/incoming payload balance among the member ports and enhance the
connection reliability.
An S3026C/S3026G/S3026T/S3026C-PWR Ethernet Switch supports at most six
aggregated groups, with each group containing a maximum of eight fixed ports or two
extended/uplink ports. The group can start from any port, as long as the ports in it are
consecutive.
An S3026E FM/S3026E FS Ethernet Switch supports at most six aggregated groups,
with each group containing a maximum of eight ports. The ports of one group located in
the same slot must be consecutive. If two slots are involved, the slot numbers should
also be consecutive and the first port in the second slot must be added to the group
first.
In a link aggregation group, the port with the smallest number serves as the master port,
and the others serve as member ports. In one link aggregation group, the link type of
the master port and the member ports must be identical. That is, the master port and
the member ports should be in Trunk mode together, or be in Access mode together.
2.2 Link Aggregation Configuration
Link aggregation configuration includes:
z
Aggregate Ethernet ports
2.2.1 Aggregate Ethernet Ports
The following command can be used for aggregating Ethernet ports or removing a
configured link aggregation.
Perform the following configuration in system view.
Table 2-1 Aggregating Ethernet ports
Operation Command
Aggregate Ethernet ports
link-aggregation port_num1 to port_num2 { both |
ingress }
Remove a configured link
aggregation
undo link-aggregation { master_port_num | all }