Huawei Quidway S3000-EI Series, Руководство по эксплуатации

Страница: 152 / 392

Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches
Chapter 1 Stack Function Configuration
Huawei Technologies Proprietary
1-2
Before setting up a stack, the user should configure a public IP address pool for the
slave switch of the stack.
Please note that the above configurations can only be performed on the non-stack
switches. After a stack is enabled, the user is prevented from modifying the IP address
pool.
1.2.2 Enable/Disable a Stack
When the user enables a stack with the following command, the system will
automatically add the switches, connected to the main switch via stack ports, to the
stack. After a stack has been enabled, if the stack port is disconnected, slave switch will
exit the stack automatically.
Perform the following configuration in system view.
Table 1-2 Enable/Disable a stack
Operation Command
Enable a stack stacking enable
Disable a stack undo stacking enable
Please note that you can only operate on the main switch to disable a stack.
1.2.3 Switch to a Slave Switch view to Perform the Configuration
The following command can be used to switch from the main switch view to a slave
switch view to change the configuration.
Please perform the following configurations in user view.
Table 1-3 Switch to a slave switch view to perform the configuration
Operation Command
Switch to a slave switch view to perform
the configuration
stacking num
Please note that the above command can only be used for switching from the main
switch view to a slave switch view and the user level remains the same after switching.
To switch from a slave switch view back to a main switch view, input quit .
1.3 Display and Debug Stack Function
After the above configuration, execute display command in any view to display the
running of the stack configuration, and to verify the effect of the configuration.