|
25
8-Channel Receiver HT200E
new transmitters can be programmed again.
If the transmitter list needs to be cleared and reset, the deletion can be made
with the following steps:
1.
Separate the receiver from the power supply.
2.
Press and hold the button 1
“learn”
.
3.
Reconnect the device to the power supply.
4.
The LED
“learn”
will light up.
5.
Wait till the LED starts blinking rapidly.
6.
Release the button
“learn”
. All programmed transmitters are now deleted
The receiver can now be programmed with new transmitters.
6. InSTallaTIOn anD cOnnEcTIOn
Connect the device to a suitable power supply (12 V DC/500 mA). Make sure
that the correct polarity of the +12 V DC is connected to the relay output. The
maximum load per relay is 230 VAC/5 A or 24 V DC/10 A. The total power
output may not exceed 3000 V.
Use the supplied rubber pads for the cable entry holes of the box. Unused holes
must be sealed with intact rubber pads. External consumers should be directly
connected to the relay terminals according to the printed circuit symbols.
As electrical loads, DC or AC can be connected, make sure that you establish
a secure connection of the cables to the terminals, particularly when connecting
mains voltage. All consumers should be protected by their individual fuse.
EXTErnal DETacHaBlE anTEnna
The antenna is mounted outside the housing with a plug connection. It It can
be detached and extended with BNC cables up to 10 meters. This allows an
individual mounting, away from the hou sing and other disturbing radio sources.
Keep the device away from sources of strong radio frequencies or magnetic
fields, as the device may start switching the relays or malfunctioning due to
the interference. If the relay is switching a touchable low voltage, then the
neighbouring relay may not be connected to or switch a dangerous voltage.
(Voltage over 35 V).
