|
23
8-Channel Receiver HT200E
3.
The switch 1.7 adjusts the follow up time of the relay:
“Off”
= follow up time 200 ms
“On”
= follow up time 500 ms
4.
The switch 1.8 switches the “Rolling-Code” on and off:
“Off”
=
Rolling-Code is on
“On”
= Rolling-Code is off
The two switches S1.7 and S1.8 can become convenient if the receiver is used
in an environment where the radio frequencies can cause interference.
The
SwITcH 1.7
in the
“On”
position makes the device sluggish and can
therefore prevent an unwanted switching when activating the trigger mode.
The
SwITcH 1.8
in the
“On”
position switches off the Rolling-Code
function. This can be convenient if the signal between transmitter and receiver
is occasionally interrupted due to high frequency interference or the reception
is bad. If the signal is interrupted during trigger mode, the device will show an
error message “RC_ERR” on one of the LEDs. It is recommended to only switch
off the Rolling-Code function, if functionality is the priority over security.
nOTE:
the changes of the DIP switches will only become effective after the
button
“reload”
has been pressed.
4. lED DISplay
The LED display consists of 17 LEDs which have the following meanings:
1 lED „power“:
The supply voltage is present .
2 lED „learn“:
The device is in learning mode.
3 lED „nO aSc“:
The device has detected a valid signal from a
transmitter, but the transmitter is not authorized to
control the device. The receiver must first learn the
code of the transmitter.
4 lED „mEm full“:
All available memory slots (32) for programming
transmitters are occupied.
5 lED „EraSE mEm“:
This LED is lit during the deletion of the memory.
6 lED „lOw BaT“:
This LED is lit when the battery voltage of the
transmitter is below 2.5V.
