24
| LED display
7 lED „mEm Err“:
This LED is lit when an error occurs when reading /
writing the EEPROM memory.
8 lED „Err rX“:
This LED is lit when a broadcast packet arrives
containing an error. (eg by external disturbances)
9 lED „rc Err“:
This LED indicates a transmitter data package with
a Rolling-Code, that has already expired. This
can happen if there was short interruption in the
transmission signal.
5. lEarnIng prOcESS
The receiver is capable of learning how to connect with 32 suitable transmitters
(e.g. H B641 or H B643). The learning process consists of the following steps:
1.
Press BTN 1
“learn”
to activate the learning sequence.
The LED “Learn” lights up to show that the programming mode is active.
2.
Within 10 seconds, press any control key of the transmitter.
*
The LED
“learn”
will start flashing if the signal is recognized.
3.
Press BTN1
“learn”
again to finalize the learning sequence.
The LED will go out.
Setting the operation mode
Setting the operation mode consists of the following steps:
1.
Press BTN 1
“learn”
to activate the learning sequence.
The LED “Learn” lights up to show that the programming mode is active.
2.
Within 10 seconds, press the
“1, 2, 3 or 4“
(see the following chart)
control key of the transmitter.
*
3.
The LED
“learn”
will blink for a short time and finalize the learning
sequence. The device will restart.
Deleting the station memory list
A maximum of 32 transmitters can be programmed. If 32 stations have al-
rea dy been programmed into the receiver, no additional transmitters can be
pro grammed. Previously learnt codes are not lost. After deleting all transmitters,
*The transmitter needs to be preprogrammed
.
