HTP Versa Hydro PHE130-119, Установка Запуск Техническое обслуживание Запасные части

Страница: 59 / 84

59
Press the
▼ key once.
This screen displays the eighth oldest lockout fault the heater control had. The top line will alternate
between the words “FAULT HISTORY” and the fault encountered. The bottom line will display the date
and time the fault occurred.
Press the
▼ key once.
This screen displays the ninth oldest lockout fault the heater control had. The top line will alternate
between the words “FAULT HISTORY” and the fault encountered. The bottom line will display the date
and time the fault occurred.
Press the
▼ key once.
This screen displays the tenth oldest lockout fault the heater control had. The top line will alternate
between the words “FAULT HISTORY” and the fault encountered. The bottom line will display the date
and time the fault occurred.
PART 10: START-UP PROCEDURE
To assure that the system is properly installed and designed correctly, it is important that the installer
follow the guidelines outline below before applying power to the unit.
FOR YOUR OWN SAFETY READ BEFORE OPERATING
This appliance does not have pilot. It is equipped with an ignition device that automatically lights the
burner. Do not try to light the burner by hand.
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas suppliers' instructions.
•
If you cannot reach your gas supplier, call the fire department.
Turn off gas shutoff valve (located inside of the cabinet) so that the handle is aligned with the gas pipe. If
the handle will not turn by hand, don't try to repair it, call a qualified service technician. Force or attempted
repair may result in a fire or explosion.
The heater shall be installed so the gas ignition system components are protected from water (dripping,
spraying, rain, etc.) during appliance operation and service (circulator replacement, condensate trap,
control replacement, etc.).
Do not use this appliance if any part has been under water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the control system and any gas control which has been
under water.