24
Using the LyncTouch
Bass
– press the “minus” and “plus” buttons to decrease/increase the amount
of bass in the zone. This adjustment can also be made within the HTD Lync
app. The default and most common setting is “0”.
Treble
– press the “minus” and “plus” buttons to decrease/increase the amount
of treble in the zone. This adjustment can also be made within the HTD Lync
app. The default and most common setting is “0”.
Balance
– press the “minus” and “plus” buttons to transfer the relative volume
level between Left (minus) and Right (plus). This adjustment can also be made
within the HTD Lync app. The default and most common setting is “0”. Balance
is only adjusted in rare circumstances where a room has an odd shape and/or
speakers are not evenly located.
Address
– When a single LyncTouch is the only device installed within a zone,
this setting is irrelevant. If an active source input panel (AIP, BIP, or DIP) is
installed into the same zone, the LyncTouch should be set to address 4. If a
second LyncTouch is installed within the same zone, it should be set to address
3. Be sure to power cycle the central Lync controller whenever you make a
change to Address.
Note: the other options (0, 1, 2) are only used for rare
system configurations. An HTD support rep will instruct when one of these
address settings should be used.
Customize how the display behaves when active and in stand-by
Level on
– The brightness level on a scale of 1 to 5 (brightest) of the touchscreen
display when the LyncTouch is being used. The default and most common
setting is “3”.
Level sleep
– The brightness level on a scale of 1 to 5 (brightest) or completely
“Off” when the zone is turned on but the LyncTouch is not actively being used.
The default and most common setting is “Off”.
Text
– The color of text that can be changed. Note that some text is always
white or gray and will not change based on this setting. The default text color
is white.
Accent
– The accent color displayed throughout screen pages. The default
accent color is blue.
Auto Wake
– When set to “Off” (default), the LyncTouch display will not light up
(wake up) when changes to the zone are made by the HTD Lync app or another
LyncTouch installed within the same zone. When set to “On”, the display will
wake up with any adjustments made to the zone.
Sleep Time
– Determines the number of seconds the screen will stay at the “Level On” brightness level after no
interaction with the LyncTouch before returning to the “Level Sleep” setting. Available in 5 second increments
between 5 and 60. 15 is the default.
Screen Settings
Screen
***To enter setup mode, press and hold the Quick Key Button for approximately 3 seconds.***
Main Settings Screen
4
