VEGA78
EN - 40
5.4.6. General
Parameters
This option permits the selection of network parameters for recording operation. This level
included several sub-level for a detailed selection depending on the type of system on test
(see § 5.3.1). Depending on the selection performed, different error screen can be shown
by meter. The below situations are possible:
Fig. 65: General Parameters section: no selection
The Fig. 65 shows the situation which the error due to no parameters selection is
performed also if the “General Parameters” is selected at display. Please note the text on
grey background and the not selected check box. In this situation other type of analysis as
Harmonics, Voltage Anomalies, etc.. are not possible. Pressing
F3
key (or touch “
SEL
” at
display) to exit from this error condition. In this order the flag of “General Parameters”
check box it will be selected and the below screen (with black text background) is shown:
Fig. 66: General Parameters section: selected parameters
In example of the above picture 32 parameters are been selected on total of maximum
251
available
and the correspondent autonomy is shown automatically by meter in this case.
CAUTION
The “General Parameters” check box activated flag, automatically select the
main electrical parameters whose number depends on the selected system
(Voltages, Currents, Frequency, Power Factor, Active, Reactive, Apparent
Powers, Active, Reactive, Apparent Energies). The failure to select “General
Parameters” flag automatically doe not select the above parameters.
The opposite situation is the error due to a too many selected parameters. In this case the
below screen is shown:
Shop for Power Metering products online at:
1.888.610.7664
www.
PowerMeterStore
.com
