Im Martelacker 12 – D-79588 Efringen-Kirchen – Phone 0 76 28 - 91 11- 0 – Fax 0 76 28 - 91 11-90
E-Mail: [email protected] – Web: www.hs-technik.com
- 28 -
Install adapters by following these steps:
Place/plug in the connection plug onto the circuit board
Insert and screw down the battery adapter
Design 4
Loosen the flathead screw in the middle
of the bottom of the battery adapter.
After loosing the battery adapter the connection plug must be removed
from the board. Hereto the small locking mechanism needs to be pushed to
open it. Then the plug can be removed. In order to connect a new battery
adapter the locking mechanism must be locked again.
Design 3
Loosen the two torx screws on the bottom
of the adapter by approx. 8 - 10 turns to the
left.
Design 2
Loosen the torx screw in the middle by
approx. a quarter of a turn to the left. Do
not loosen the screws to far, because the
nut can be loosen then too.
