You can now stand the frame up on its four feet. Clear any objects out of the way
first to prevent damage to them or the stand. Then, at least two people should lift
the top of the stand together to tip it onto its feet (see Photo 21). If your stand is
only one column wide, skip the following instructions for doublewide systems and
refer to the steps for final assembly.
Photo 21
Doublewide Systems -
The second column of the stand will be built off the first
while it is standing as shown in Photo 21. First loosen the sixteen fasteners
holding the horizontal crossmember subassembly rigid as you did for the ones in
the first column. The eight on the top of the subassembly are circled in Photo 22
and there are eight more opposite them on the underside of the subassembly.
Loosen the two fasteners at either end of each brace on both the top and bottom
by 1/4 turn (four fasteners per brace per side for a total of sixteen). Do not loosen
the two fasteners at the center of each of the braces; they must remain torqued as
delivered. Remove one horizontal brace subassembly from it’s crate and use the
5/32” T-wrench or ratchet wrench supplied with the VXR to loosen (counter
clockwise) the sixteen bolts that connect to the isolation base mounts. Only loosen
each fastener 1/4 turn to give the assembly some flexibility for easy installation.
Photo 22