Install feet, nuts, and washers on the vertical leg subassemblies in the same way
you did the first set. Unwrap two of the four feet supplied with the unit. Remove
the nut and washer from each foot (see Photo 12).
Photo 12
Hand-tighten the nut all the way down on each individual foot. Then back the nut
off one half rotation (see Photo 13).
Photo 13
Place the supplied washer on top of the nut and then screw each of the feet into
the threaded inserts on the bottom of the first vertical leg subassembly (see
Photos 14 & 15). The feet should be threaded into the insert until the washer is
held in contact with the bottom of the leg. (This ensures maximum engagement
between the insert and the foot).
Photo 14
Photo 15
