TITLE
:
TJA Series Guideline
ETAD-E3232-00
Rev No. 0
HIROSE ELECTRIC CO.,LTD.
OBJECT
PRODUCT
:
TJA Series
PAGE:
17
OF
25
3.2 Plug Installation Procedures
<<Plug>>
1. Insert the crimped female contact in the direction of the arrow until it reaches the inside
of the housing. The contact lance is on the side without the housing polarity mark (Δ).
2. Insert the S housing into Unit A in the direction where the distinction mark is visible.
(It is designed so insertion to the other side is not possible.)
3. Attach the metal clamp to Unit A and tighten the cable. Make sure it is in the right position
with the slide buttons as shown, then cover Unit B from above, and screw it in three places.
(Recommended tightening torque 0.315 ± 0.06 N·m)
When using a metal clamp for ground connection, wrap a copper tape around the braid shield
And secure that part with a metal clamp. Depending on the type and number of wires, if the
cmetal clamp and the copper tape do not contact with the product, adjust the thickness with
plastic tape or copper tape.
For ground connection using a commercially available ring terminal, after crimping the ring
terminal, secure it to the ground wire with a M3 screw.
(Recommended tightening torque 0.315 ± 0.06 N·m)
4. Insert the key(sold separately) into the plug body
and tighten the screw.
(Recommended tightening torque 0.18 ± 0.03 N·m)
Metal Clamp
Screw
fastening
part
Ground Wire
connection part
Slide Button
Unit B
Contact Lance
Side Without Polarity Mark
Distinction Mark
Unit A
Aug.1.2022 Copyright 2022 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
