340
[SwitchB-GigabitEthernet1/0/3] quit
4.
Configure the RADIUS server:
On the RADIUS server, configure the parameters related to Switch A and Switch B. For more
information, see the configuration guide of the RADIUS server.
Verifying the configuration
After the configurations, the two multicast sources and hosts initiate 802.1X authentication. After
passing the authentication, Source 1 sends multicast flows to FF1E::101 and Source 2 sends
multicast flows to FF1E::102; Host A sends report messages to join IPv6 multicast groups FF1E::101
and FF1E::102. Use the
display mld-snooping group
command to display information about MLD
snooping groups. For example:
# Display information about MLD snooping groups in VLAN 104 on Switch B.
[SwitchB] display mld-snooping group vlan 104 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, C-Copy port, P-PIM port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 1 port(s).
GE1/0/1 (D) ( 00:01:30 )
IP group(s):the following ip group(s) match to one mac group.
IP group address:FF1E::101
(::, FF1E::101):
Attribute: Host Port
Host port(s):total 1 port(s).
GE1/0/3 (D) ( 00:04:10 )
MAC group(s):
MAC group address:3333-0000-0101
Host port(s):total 1 port(s).
GE1/0/3
The output shows that GigabitEthernet 1/0/3 on Switch B has joined FF1E::101 but not FF1E::102.
Assume that Source 2 starts sending multicast traffic to FF1E::101. Use the
display multicast ipv6
forwarding-table
to display the IPv6 multicast forwarding table information.
# Display the information about FF1E::101 in the IPv6 multicast forwarding table on Switch A.
[SwitchA] display multicast ipv6 forwarding-table ff1e::101
IPv6 Multicast Forwarding Table
Total 1 entry
Total 1 entry matched
00001. (1::1, FF1E::101)
MID: 0, Flags: 0x0:0
Uptime: 00:08:32, Timeout in: 00:03:26
Incoming interface: Vlan-interface101
