HP StorageWorks DLT80, Справочное руководство

Страница: 48 / 74

Operating the DLT80 Tape Drive
48 DLT80 Tape Drive Reference Guide
The following table describes the front panel buttons:
Caution: Inserting a cartridge while the Operate Handle LED is flashing may
damage the tape drive.
Table 6: Front Panel Buttons
Control Button Description
Unload Starts the cartridge unload sequence. The cartridge must be
completely rewound before the cartridge can be removed.
When the Unload button is pressed, the DLT drive waits until an
active write to cartridge is completed before beginning the
unload sequence. If the drive is in an error state (all right-side
and left-sided lights are flashing on the front panel), pushing
the Unload button causes the drive to reset and unload the tape
if possible.
Note: The cartridge cannot be manually unloaded if there is no
power to the DLT drive.
Density Select Selects desired density. After density is selected, pressing this
button turns compression on or off.
Cartridge Insert/
Release Handle
The handle lifts to load or eject a cartridge. Lowering the
handle locks the cartridge into position.
Note: When the drive is first powered on, the Cartridge
Insert/Release Handle must be in the down position. Operate
the Handle only when the Operate Handle LED is illuminated.