●
Heat sink (
Heat sink on page 91
)
●
Processor (
Processor on page 92
)
4.
Remove the riser card cage
Replacing the Riser Card on page 67
.
5.
Remove the fan duct (
Fan Duct on page 84
).
6.
Remove the chassis fan (
Front Fan on page 86
).
7.
Rotate the drive cage to its full upright position.
8.
Rotate the power supply to its upright position.
9.
Disconnect all data, power, and any other cables from the system board.
10.
Remove the eight screws
(1)
that secure the system board to the floor of the chassis.
11.
Slide the system board tray assembly toward the front of the chassis
(2)
to disengage the rear
ports, and then lift the system board up and out of the chassis
(3)
.
Figure 7-59
Removing the System Board
To install the system board, reverse the removal procedure.
CAUTION:
Before reinstalling the heatsink you must clean the top of the processor and the bottom
of the heatsink with an alcohol pad supplied in the spares kit. After the alcohol has evaporated, apply
thermal grease to the top of the processor from the syringe supplied in the spares kit.
CAUTION:
When reconnecting the cables it is important that they be positioned so they do not
interfere with the rotation of the drive cage or power supply.
System Board
95
Содержание rp5800
Страница 1: ...Maintenance Service Guide HP rp5800 Retail System ...
Страница 4: ...iv About This Book ...
Страница 10: ...x ...
