Converter board
The converter board is located on the left side of the computer (viewed from behind) under the main rear
cover. It is secured with two Torx screws and has two connectors.
Use the same converter spare part for all display panels.
NOTE:
When replacing the converter board, be sure to use the matching backlight cable for the panel.
To remove the converter board:
1.
Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 22
).
2.
Remove the rear port cover (see
Rear port cover on page 23
).
3.
Remove the stand (see
Attaching and removing a stand on page 24
).
4.
Remove the access panel (see
Access panel on page 28
).
5.
Disconnect the two cables from the board (1).
NOTE:
Be careful not to damage the cables when disconnecting them from the board. Do not pull on
the wires.
6.
Remove the two Torx screws (2) that secure the board to the computer.
7.
Lift the converter board from the computer.
To install the converter board, reverse the removal procedures.
Converter board
33
Содержание proone 400 g2
Страница 4: ...iv About This Book ...
Страница 10: ...x ...
Страница 73: ...9 Rotate the trim off the computer To install the left trim reverse the removal procedures Left trim 63 ...