Display panel, non-touch
IMPORTANT:
Install the new display panel together with all other parts in the replacement kit. Do not reuse
any old parts. Return all old parts to HP for warranty processing.
CAUTION:
it is very important to use the exact cable that shipped with the replacement panel. Failure to use
the correct cable may result in panel failure.
To remove the display panel:
1.
Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 22
).
2.
Remove the rear port cover (see
Rear port cover on page 23
).
3.
Remove the stand (see
Attaching and removing a stand on page 24
).
4.
Remove the access panel (see
Access panel on page 28
).
5.
Remove the optical drive (see
Replacing the optical drive on page 31
).
6.
Remove the system board shield (see
System board (EMI) shield on page 37
).
7.
Remove the heat sink (see
Heat sink on page 46
).
8.
Remove the speakers (see
Speakers on page 54
).
9.
Remove the top trim (see
Top trim on page 34
).
10.
Remove the right trim (see
Right trim on page 60
).
11.
Remove the rear I/O cover and bottom trim (see
Rear I/O cover and bottom trim on page 64
).
12.
To separate the bezel from the main frame, remove the two Torx screws that secure the bezel to the
frame (1).
13.
Disengage the tabs along the sides that secure the bezel to the frame. Tabs are as follows:
(2) 5 tabs along the left side
(3) 6 tabs along the top
(4) 3 tabs on the right side (1 tab under system board (5))
14.
Remove the speaker wire from the routing path on the bottom of the bezel (5).
Display panel, non-touch
65
Содержание proone 400 g2
Страница 4: ...iv About This Book ...
Страница 10: ...x ...
Страница 73: ...9 Rotate the trim off the computer To install the left trim reverse the removal procedures Left trim 63 ...
