●
The system will operate in a higher-performing dual channel mode if the memory capacity of the
SODIMM in Channel A is equal to the memory capacity of the SODIMM in Channel B.
●
In any mode, the maximum operational speed is determined by the slowest SODIMM in the system.
To remove a memory module:
1.
Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 22
).
2.
Remove the rear port cover (see
Rear port cover on page 23
).
3.
Remove the stand (see
Attaching and removing a stand on page 24
).
4.
Remove the access panel (see
Access panel on page 28
).
5.
Remove the system board shield (see
System board (EMI) shield on page 37
).
6.
To remove a memory module, press outward on the two latches on each side of the SODIMM (1), then
pull the SODIMM out of the socket (2).
7.
To install a memory module, slide the SODIMM into the socket at approximately a 30° angle (1), then
press the SODIMM down (2) so that the latches lock it in place.
NOTE:
A memory module can be installed in only one way. Match the notch on the module with the tab
on the memory socket.
Memory
39
Содержание proone 400 g2
Страница 4: ...iv About This Book ...
Страница 10: ...x ...
Страница 73: ...9 Rotate the trim off the computer To install the left trim reverse the removal procedures Left trim 63 ...
