HP Proliant DL580, Руководство по техническому обслуживанию и ремонту

Страница: 47 / 137

Removal and replacement procedures 47
9. Lift the levers, and pull the SCSI backplane out of the server.
IMPORTANT: Be sure to set the SCSI simplex/duplex switch to
the appropriate setting when replacing the SCSI backplane.
To replace the component, reverse the removal procedure.
Removing the power backplane
1. Power down the server ("Powering down the server" on page 18 ).
2. Remove all power supplies ("Removing a redundant hot-plug power supply"
on page
59 ) and power supply blanks ("Removing a power supply blank" on
page 58 ).
NOTE: If you remove or replace the primary hot-plug power
supply, use the T-15 Torx screwdriver provided with the server to
remove the shipping screw. It is located just under the port-colored
plastic handle of the power supply unit.
3. Extend or remove the server from the rack ("Removing the server from the
rack" on page
19 ).
4. Remove the access panel ("Removing the access panel" on page 19 ).
5. Remove the system cage ("Removing the system cage" on page 20 ).