Removal and replacement procedures 40
Hot-plug drive
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
1.
Back up all server data.
2.
If installed, remove the security bezel ("
Remove the security bezel (optional)
" on page
29
).
3.
Determine the status of the drive from the drive LED definitions ("
Hot-plug drive LED definitions
" on
page
97
).
4.
Remove the hot-plug drive.
To replace the component, reverse the removal procedure.
Access panel
To remove the component:
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
Do not operate the server for long periods with the access panel open or
removed. Operating the server in this manner results in improper airflow and improper cooling
that can lead to thermal damage.
1.
Power down the server (on page
30
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
30
).
o
Remove the server from the rack (on page
33
).
4.
Open the access panel latch, slide the access panel to the rear of the chassis, and then remove the
access panel.
Содержание ProLiant DL120 Gen9
