Hardware options installation 88
The plastic bracket ships with the expander card. For more information, see the documentation that
ships with the option.
9.
Install the expander card ("
Expansion board options
" on page
78
).
10.
Route and connect the cables.
For more information, see the documentation that ships with the expander card.
11.
Install the fan cage.
12.
Install the air baffle.
13.
If removed, install the BBWC battery pack or the FBWC capacitor pack ("
Installing the BBWC battery
pack or the FBWC capacitor pack
" on page
86
).
14.
Install fan 5.
15.
Install the access panel.
16.
Do one of the following:
o
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
17.
Power up the server (on page
22
, "
Powering up and configuring the server
" on page
40
).
Graphics adapter option
The server supports up to three high-power graphics adapters.
Install graphics adapters in the x16 PCIe expansion slots. For more information, see "System board
components (on page
13
)."
Before installing a high-power graphics adapter in the server, be sure that the power supplies support the
installation of the adapter. Due the high power requirements for the adapter, a 750W or higher power
supply may be required. For more information, see the HP Enterprise Configurator website
(
http://h30099.www3.hp.com/configurator/
).
To install the component:
1.
Power down the server (on page
22
).
2.
Do one of the following:
o
Open or remove the tower bezel, as needed ("
Open or remove the tower bezel
" on page
22
).
o
Extend the server from the rack (on page
24
).
3.
Remove the access panel (on page
25
).
4.
Remove fan 5 (on page
26
).
5.
If installed, remove the BBWC battery pack or the FBWC capacitor pack (on page
27
).
6.
Remove the air baffle (on page
28
).
7.
Remove the fan cage (on page
29
).
8.
Install the graphics adapter in a x16 PCIe expansion slot ("
Expansion board options
" on page
78
).
9.
Connect the power cables.
For more information, see the documentation that ships with the graphics adapter power cable kit.
10.
Install the fan cage.
11.
Install the air baffle.
Содержание ProLiant DL G6
