HP ProCurve Radio Port 210, Руководство по установке и началу работы

Страница: 14 / 36

2-4
Installation Instructions
Wall Mount
In
sta
lla
tio
n
In
str
u
c
tio
n
s
Wall Mount Procedure
1. Lightly mark a vertical line on the wall at the location where the midline
of the radio port is to be located.
2. Use the alignment arrows, move the edge of the radio port to the midline
from step 1 and mark the two points on the midline for the location of the
mounting screws. (See following diagram)
3. At each of the two points, drill a hole in the wall, insert an anchor (if
required), screw the wall mounting screw into the anchor and stop when
there is 2 mm remaining between the screw head and the wall.
N O T E
When pre-drilling holes, the recommended hole size is 3mm (0.125 or 1/8 in.)
if the screws are going directly into the wall and 6mm (0.25 or 1/4 in.) if the
provided wall anchors are being used.
4. Loop a safety wire through the tie point and secure the loop. Attach the
opposite end of the safety wire to a secure point on the wall.
5. Install a security cable to the radio port's lock port and attach the opposite
end of the security cable to a secure, stationary point.
Use these alignment arrows to mark the wall in preparation for installing mounting screws