HP ProCurve 1600M, Руководство по управлению и настройке

Страница: 598 / 690

Troubleshooting
Unusual Network Activity
C a u t i o n
N o t e
LACP-Related Problems
Unable to enable LACP on a port with the
interface < port-number > lacp
command. In this case, the switch displays the following message:
Operation is not allowed for a trunked port.
You cannot enable LACP on a port while it is configured as static
Trunk
port.
To enable LACP on static-trunked port, first use the
no trunk < port-number >
command to disable the static trunk assignment, then
execute
interface < port-number > lacp
.
Removing a port from a trunk without first disabling the port can create a
traffic loop that can slow down or halt your network. Before removing a port
from a trunk, ProCurve recommends that you either disable the port or
disconnect it from the LAN.
Mesh-Related Problems
Traffic on a dynamic VLAN does not get through the switch mesh .
GVRP enables dynamic VLANs. Ensure that all switches in the mesh have
GVRP enabled.
Port-Based Access Control (802.1X)-Related Problems
To list the 802.1X port-access Event Log messages stored on the switch, use
show log 802
.
See also “Radius-Related Problems” on page C-17.
The switch does not receive a response to RADIUS authentication
requests.
In this case, the switch will attempt authentication using the
secondary method configured for the type of access you are using (console,
Telnet, or SSH).
There can be several reasons for not receiving a response to an authentication
request. Do the following:
■ Use
ping
to ensure that the switch has access to the configured RADIUS
servers.
■
Verify that the switch is using the correct encryption key (RADIUS secret
key) for each server.
C-14