HP DL120 - ProLiant - G5, Руководство пользователя

Страница: 38 / 113

Hardware options installation 38
5.
Connect the SAS hard drive LED cable to the system board and to the SAS controller.
6.
Install the access panel.
7.
Install the server into the rack.
Battery-backed write cache battery pack option
CAUTION: To prevent a server malfunction or damage to the equipment, do not add or remove
the battery pack while an array capacity expansion, RAID level migration, or stripe size migration
is in progress.
CAUTION: After the server is powered down, wait 15 seconds and then check the amber LED
before unplugging the cable from the cache module. If the amber LED blinks after 15 seconds, do
not remove the cable from the cache module. The cache module is backing up data, and data is
lost if the cable is detached.
IMPORTANT: The battery pack might have a low charge when installed. In this case, a POST
error message is displayed when the server is powered up, indicating that the battery pack is
temporarily disabled. No action is necessary on your part. The internal circuitry automatically
recharges the batteries and enables the battery pack. This process might take up to four hours.
During this time, the cache module functions properly, but without the performance advantage of
the battery pack.
NOTE: The data protection and the time limit also apply if a power outage occurs. When power
is restored to the system, an initialization process writes the preserved data to the hard drives.
To install the component:
1.
Power down the server (on page 15 ).
2.
Remove the server from the rack (on page 15 ).
3.
Remove the access panel (on page 16 ).
4.
Install the storage controller, if not installed (" Storage controller option " on page 37 ).