Hardware options installation 26
Installing DIMMs
CAUTION:
To avoid damage to the hard drives, memory, and other system components, the air
baffle, drive blanks, and access panel must be installed when the server is powered up.
1.
Power down the server (on page
15
).
2.
Remove the server from the rack (on page
15
).
3.
Remove the access panel (on page
16
).
4.
Remove the air baffle (on page
16
).
For more information, see the server installation sheet on the HP website
(
http://www.hp.com/go/bizsupport
).
5.
Open the DIMM slot latches.
6.
Install the DIMM.
7.
Install the air baffle.
8.
Install the access panel.
9.
Install the server into the rack.
Hard drive options
The server provides non-hot-plug capability through an embedded SATA controller. To obtain hot-plug
capability, install an optional controller and hot-plug cable option kit.
Hard drive guidelines
When adding hard drives to the server, observe the following general guidelines:
•
The system automatically sets all drive numbers.
•
If only one hard drive is used, install it in the bay with the lowest drive number.
•
Drives must be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Содержание DL120 - ProLiant - G5
