HP C7745NB - SureStore DLT Tape Autoloader 1/9, Руководство по обслуживанию

Страница: 25 / 153

Chapter 1 Installing the Autoloader into a Rack 25
Ch
ap
ter
1
5. Install the 55-mm spacer bracket to each front rack column by aligning the
top of the bracket with the top clip nut and tightening the two pre-installed
Phillips screws (see Figure 6 ).
6. Slide the tray on top of the mounting rails to the back of the rack
(see Figure 6 ).
7. Tighten the pre-installed T-20 screws on each side of the tray front to
secure the tray to the installed spacer brackets on the rack. You might need
to support the tray while you are tightening the screws.
Figure 6 Installing the Tray
8. Using two people or an appropriately rated lift, install the autoloader onto
the right side of the tray, gently sliding it toward the back of the rack.
Ensure that the front edge of the autoloader is still accessible for the next
step.