HP SureStore DAT
Installing an “eU” Model Drive (external for Unix)
2-3
Before You Start: Check System Prerequisites
To install and use your new tape drive, you will need the following:
• SCSI host adapter
• SCSI cable
• Backup software that supports the tape drive
SCSI Host Adapter
You need a properly installed and configured SCSI host adapter or a built-
in SCSI controller on your computer’s motherboard (SCSI-2 or SCSI-3
compliant). Consult your supplier for details.
If you would like more information on configuring your SCSI bus, read the
“SCSI Background” topic in the “Before You Start” section of the electronic
User’s Guide on the CD-ROM.
SCSI Cable
If the SCSI cable supplied with your drive is not appropriate for your
computer’s external SCSI connector, you will need to order a new cable.
(For HP part numbers and descriptions, see the electronic DAT Media and
Orderable Accessories Guide on the HP SureStore Tape CD-ROM.)
– The cable provided with DAT8eU and DAT24eU drives will attach to
a computer with a wide SCSI connector (68 pins).
– The cable provided with Tape 5000eU drives will attach to a high-
density narrow SCSI connector (50 pins).
Backup Software
You need backup software that supports the drive.
Applications usually recognize tape drives by their manufacturers’ internal
identifiers rather than their model numbers, so check the table below for
the appropriate reference for your model.
Drive Model
Internal Identifier
HP SureStore Tape 5000
HP 35480A
HP SureStore DAT8
HP C1533A
HP SureStore DAT24
HP C1537A
Dat-ext.bk Page 3 Wednesday, May 26, 1999 9:44 AM
