U.S.A.
Radio Frequency Interference Statement
(Federal Communications Commission)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, you are
encouraged to try to correct the interference by one
or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
and the receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
•
Consult your dealer or an experienced radio/TV
technician for help.
Note that if you change or modify the equipment in
a way that is not expressly approved by Hewlett-
Packard, any assurances of safety or performance
can no longer be held to apply, and could result in
violation of Part 15 of the FCC Rules.
Interference
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
(2) this device must accept any interference
received including interference that may cause
undesired operations.
WARNING: Only the double-shielded data cable
supplied by the manufacturer should be used with
external tape drives. Other types of cables could
void the manufacturer's warranty and violate FCC
rules and regulations.
Japan
Korea
Dat-ext.bk Page 5 Wednesday, May 26, 1999 9:44 AM
