HP SureStore DAT
Installing an “e” Model Drive (external)
1-10
Step 3: Connect the Power Cable
An external HP SureStore DAT drive will operate using any voltage in the
range 100–240 volts (50-60 Hz). No adjustment is needed. To connect your
drive to the power supply, proceed as follows:
1
Make sure that the drive is switched OFF (O side down). The power switch
is on the rear panel (see figure 1.3).
2
Plug the power cable securely into the socket on the rear panel of the drive.
3
Plug the other end of the power cable into the power outlet.
Note
Write the model name, product number, serial number, and SCSI ID of
your drive in the front of this guide for future reference. The model name
is on the front of the drive and the product and serial numbers are on a
label on the bottom of the drive.
Dat-ext.bk Page 10 Wednesday, May 26, 1999 9:44 AM
