Power cord information
CAUTION:
• Use only Aruba-approved and recommended power cords. For proper power cord selection,
see Power cords, power inlet accessories, and power supplies.
• If your installation requires a different power cord than the one supplied with the chassis or
power supply unit, be sure the cord is adequately sized for the chassis or PSU current
requirements. In addition, be sure to use a power cord displaying the mark of the safety
agency that defines the regulations for power cords in your country. The mark is your
assurance that the power cord can be used safely with the chassis and PSU.
Attaching an ESD wrist strap
Aruba provides an ESD wrist strap with the switch. To minimize ESD damage to electronic components, wear
the ESD wrist strap and make sure it is reliably grounded when handling, installing, or removing switch
components.
To use an ESD wrist strap:
Prerequisites
• See Preventing electrostatic discharge damage.
• Locate the ESD wrist strap shipped with your Aruba 6400 switch.
Procedure
1. Put on the wrist strap.
2. Tighten the wrist strap to make sure it makes good skin contact. Make sure the resistance reading
between your body and the ground is between 1 and 10 megohms.
3. Attach the wrist strap securely to the front or rear of the chassis.
2
1
42
Aruba 6400 Switch Series Installation and Getting Started
Guide
Содержание Aruba 6400 Series
Страница 77: ...Chapter 7 Installing components 77 ...
