HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive, Руководство по техническому обслуживанию и ремонту

Страница: 84 / 120

Installing the controller
1. Insert the new or serviced array controller into the MSA chassis controller bay ( 1 ).
2. Push the controller in as far as it will go, making sure that the controller is seated, and then press the
latch handle inward until it is fl ush against the front panel ( 2 ).
1
2
15493
3. If necessary, power on the MSA as instructed in Connecting the Power and Applying power to
the MSA .
NOTE:
Each time a system with two controllers is powered on or restarted, or if a second controller is
hot-plugged into a single-controller con fi guration, the fi rmware versions on the controllers are compared.
If the fi rmware versions on the two controllers are not the same, the controller LCD panel prompts to clone
the fi rmware from the controller with the latest version onto the other controller. For information, see
Cloning controller fi rmware .
Verifying proper operation
After replacing the array controller, controller cache module, or cache module battery pack, verify that:
• The controller Heartbeat LED is blinking.
• The controller Fault LED is off.
• No new error messages are displayed on the array controller LCD display panel.
After installing a new array controller, verify that the latest available fi rmware is installed. See Array
controller fi rmware for the following instructions:
• Determining the currently-installed fi rmware version
• Updating controller fi rmware
• Cloning controller fi rmware
• Recovering corrupted fi rmware
84
Customer replaceable components