Table 30 Cabling pinouts
Pin
Signal
Description
1
Not supported
Not supported
2
RxData
Receive data
3
TxData
Transmit data
4
Not supported
Not supported
5
GND
Logic ground
6
Not supported
Not supported
7
Not supported
Not supported
8
Not supported
Not supported
9
Not supported
Not supported
A 3.0 m (10 ft) serial cable is provided with the switch. It can be converted from a DB-9
serial cable to an RJ-45 serial cable by removing the adapter on the end of the cable.
To remove the adapter from the end of the DB-9 serial cable:
1.
Ensure that the cable and both screws have been disengaged.
2.
Pull the adapter straight out, without moving it from side to side, to loosen the
seating of the connector. If you move the adapter side to side, you might damage it.
CAUTION:
When removing the DB-9 male connector from the DTE port, do not use excessive
force or the DB-9 connector will split into two parts easily to prevent damage to the
switch’s DTE port.
142
SAN Switch technical specifications
Содержание AA-RWF3A-TE
