HP A7340A - Surestore FC 1Gb/2Gb Switch 16B, Руководство по установке

Страница: 81 / 120

Managing the SAN Switch 2/16
81 SAN Switch 2/16 Version 3.1.x Installation Guide
6. At the
New Password
prompt, enter the new password exactly as entered to
the previous prompt.
7. Press Enter to commit the configuration to the firmware.
Configuring the IP and Fibre Channel Address
The SAN Switch 2/16 is shipped with a default IP address of
10.77.77.77
.
Use these steps to change the default IP Address and configure the Fibre Channel
IP address of the switch.
1. Log in to the switch as the admin user.
2. At the command line, enter the following command:
ipAddrSet
An interactive session is opened and you are prompted for configuration
values. Press Enter to skip a prompt and leave the parameter value as is.
3. At the
Ethernet IP Address
prompt, enter the new IP address for the
Ethernet port on the switch. Press the Enter to continue.
4. At the
Ethernet Subnetmask
prompt, enter the address of the
subnetmask, if applicable. Press Enter to continue.
5. At the
Fibre Channel IP address
prompt, enter the Fibre Channel IP
address for the switch. Press Enter to continue.
6. At the
Fibre Channel Subnetmask
prompt, enter the address of the
subnetmask, if applicable. Press Enter to continue.
7. At the
Gateway Address
prompt, enter the IP address of the gateway
system if applicable. Press Enter to continue.
The configuration is then committed to the switch firmware.
8. You are then prompted either to make the IP address changes active now or at
the next reboot. Enter
y
at the prompt to have the IP address changes take
effect immediately.