44
3.
Remove the dust plug of the transceiver module, plug one end of the optical fiber into the
transceiver module, and plug the other end into the transceiver module in the peer device, as
shown in
Figure 34
.
The transmit port on one end must connect to the receive port on the other end.
4.
Check the port LEDs for incorrect connection.
For more information about the LED status, see the chapter “Appendix C LEDs.”
WARNING!
To avoid injury to your eyes, do not stare at the optical interfaces and optical fiber connectors when
connecting optical fibers.
Figure 34 Use LC optical fiber connectors to connect transceiver modules
LC plug
SFP module
Testing the connectivity
After you plug the switch into the network, use the
ping
or
tracert
command to test the network
connectivity. For more information about these commands, see
HP A10500 Switch Series Command
References
.
