HP 70310A, Руководство по установке и проверке

Страница: 34 / 66

Connecting the Rear-P anel Cables
This section contains the following information:
Instructions for connecting the HP 70310A standard module when it is used in an HP 71210A
Microwave Spectrum Analyzer system, and a list of additional connections that are available
for a standard module .
Information about connecting HP 70310A Option 001 modules .
Information about connecting HP 70310A Option 002 modules .
Refer to Chapter 3 for input and output specications and characteristics .
HP 70310A Standard
Figure 2-7 shows the rear-panel connections of an HP 71210A system. The HP 70310A module
shown in this example is a standard module that is using its internal oven/oscillator as the
frequency reference .
HP 71210A System Connections
F ollow the steps below to connect the HP 70310A module as shown in Figure 2-7:
1. Connect the external power-pack cable to the HP 70310A module's rear-panel EXT PWR
connector .
2. Plug the external power-pack line cord into an appropriate ac power source .
3. Connect the HP 70310A module's 100 MHz output to the HP 70900A module's 100 MHz IN
connector .
Other Congurations
In addition to the connections shown in Figure 2-7, a standard HP 70310A module has the
following connections available:
An external frequency-reference signal can be connected to the module's EXT REF input
connector . If an external frequency-reference signal is connected, the module's internal
frequency reference is automatically switched o.
The module's 10 MHz output can be used to provide a stable 10 MHz reference frequency to
another instrument.
2-8 Installation