8 of 33
Service Manual UK
Indesit
Company
English
Levelling
Connect to the Water Supply
The water tap and standpipe should be situated away from the rear of appliance but in easy access for
turning on and off.
Connect to a Drainage System
Connect up the drain hose, after fitting the hooked end support supplied in the machine.
Ensure the drainage hose is not obstructed, trapped or kinked.
The drainage pipe should not be extended on these models.
Do not position standpipe near an electrical outlet. We recommend one of the following drainage
methods:- (on following page)
1. Install the washer dryer on a flat sturdy floor, without
resting it up against walls, cabinets etc.
2. If the floor is not perfectly level, compensate for any
unevenness by tightening or loosening the adjustable
front feet (see figure); the angle of inclination, measured
according to the worktop, must not exceed 2°.
For the machine to operate correctly it requires water
pressures in the range of 0.5bar (0.05MPa) to 10bar
(1.0 MPa). Most water supplies will be in this range.
Connect the hose to the water supply pipe at the rear
of the appliance and onto the cold water supply tap.
Remember to insert a sealing washer (A) to ensure
each connection is watertight.
Fit securely and turn on the water supply to check for
leaks. If there is a leak, turn off the water supply,
remove the connector and check that the sealing
washer is in place.
Refit the connector and tighten it. Turn on the water
supply.
Note:
Do not over tighten the water supply pipe
connection. Hand tight should be sufficient.
We recommend you use the new hose provided with
your appliance to ensure correct connection and
prevent leaks.
