31 of 33
Indesit
Company
Service Manual UK
English
P
Power Module
1. Remove the back panel (B).
2. Remove 2 screws securing the module support to the cabinet.
3. Disconnect the wiring - note plug positions.
4. Lift module and support clear.
Q Door Seal Retainer to Outer Case
1. The door seal is fixed to the cabinet front panel by a wire clamp and a small spring.
2. The spring is usually at the bottom of the door.
3. Carefully attached a small screwdriver to one of the ears of the spring. By stretching the spring the
wire band can be removed.
R Shock Absorbers
1. Using suitable protection lean the appliance onto one side.
2. Remove the 10 mm nut securing the shock absorber to the cabinet.
3. Push the shock absorber on the rod until it comes out of the cabinet.
4. Remove the plastic expansion rivets fixing the shock absorbers to the outer drum / tank assembly.
continued overleaf...
IMPORTANT NOTE
This appliance is manufactured with a '3 phase'
motor and uses a different type of power module.
This power board is fitted with a large aluminium
heat sink which remains live after the power is
disconnected.
Under no circumstances should the board be
removed until the machine has been disconnected
from the electricity supply for
5 minutes.
Alternative 'quick methods' of discharging the
board SHOULD NOT be used or attempted.
