Hotpoint Ariston 61359, Информация о сервисе

Страница: 20 / 22

20 of 22
Service Manual UK
Indesit Company
English
8. Remove the lower rear access panel (B).
9. Remove the motor (M).
10. Detach the drum from the damper units by removing the two plastic pegs using special
tool Part No. C00141734.
11. Remove the sump hose fixing clip and detach the sump hose from the sump chamber.
12. Disconnect heater / thermistor wiring and release the wiring harness from the drum clips.
13. Unclip any wiring retained within the integral clip on the spring bearing keeper plates.
14. Gently lever out the spring bearing keeper plates with a small flat bladed screwdriver.
15. Unhook springs from the cabinet top rail bearings.
16. Carefully lift the drum assembly out of the cabinet.
V(b) Inner Drum & Support Assembly / Drum Seal / Outer Drum Halves (see note below)
1. Remove the drum assembly (Va).
2. Remove the drum pulley (Q).
3. Loosen the inner drum assembly by tapping the drum shaft with a soft copper hammer or by
inserting a pin punch into the shaft hole and tapping with a copper hammer.
4. Remove sixteen T30 Torx head drum fixing screws and detach the drum front.
5. Lift out the inner drum and support assembly.
6. The inner drum and support are not designed to be separated, and must be replaced as an
assembly if required.
7. Always fit a replacement drum seal if the drum has been split and ensure that the seal joint is at
the top. When reassembling the drum halves it is essential to ensure that the thread forming screws
find their original threads, otherwise the thread can be stripped from the plastic drum lugs.
Retighten the drum joint fixing screws to 8Nm (using a suitable torque-wrench).
W Cabinet
1. Remove the table top (A).
2. Remove the dispenser drawer (C) and console panel (D).
3. Remove the front panel (J).
4. Remove the lower balance weight (Na).
5. Remove the lower rear access panel (B).
6. Remove the motor (M).
7. Remove the top balance weight (Nb).
8. Remove the drum assembly (Va).
9. Remove the drain pump (T).
10. Unscrew the feet, remove the wheels and remove hose clips from the rear of the cabinet.