15 of 22
Indesit
Company
Service Manual UK
English
DISMANTLING INSTRUCTIONS
SAFETY NOTES
1.
Ensure that the appliance is disconnected from the electrical supply before dismantling.
2.
Beware of sharp edges on metal panels, plastic mouldings, and pressed parts.
3.
Some fixings (especially those into plastic) must be tightened to the correct specification using a
suitable torque wrench.
4.
Insulation resistance tests must be carried out with the pressure switch set to ensure that the water
heater is 'in-circuit' during the test.
These appliances are manufactured with a '3 phase' motor and uses a different type of power
module.
This power board is fitted with a large aluminium heat sink which remains live after
the power is disconnected.
Under no circumstances
should the board be removed under the time shown below.
Alternative 'quick methods' of discharging the board
SHOULD NOT
be used or attempted.!
A
Table Top
1.
Remove the two screws at the top rear of cabinet.
2.
Slide the table top backwards to disengage the location fixings at the rear and lift off.
B
Lower Rear Access Panel
1.
Remove three screws from the lower rear access panel.
2.
Pull the top edge of the panel out and disengage it from its location fixings along the bottom.
C
Dispenser Drawer
1.
Open the dispenser drawer fully. Holding the dispenser firmly, lift the right hand side and slide
towards you.
2. Remove the drawer pivot pin and remove the drawer front.
D
Console Panel
1.
Remove the table top (A).
2.
Remove the dispenser drawer (C).
3.
Remove two top screws securing the panel to the cabinet and two screws securing the panel to the
dispenser.
4.
Unplug the wiring from the cabinet side to the console PCB - taking note of position.
5.
Remove two screws from the valve support plate and move the dispenser to the rear.
6.
Unclip two plastic lugs securing the console panel to the front panel and lift clear.
7.
Avoid unclipping and handling the control board unless absolutely necessary, as the control board
is susceptible to static electricity.
IMPORTANT NOTE
Risk of Electric Shock
The metal heatsink fitted on the Power Module
may hold an electrical charge for a short period
after switching off the machine.
Allow 5 minutes after disconnecting the
machine from the electrical supply before
commencing ANY work.
