11 of 22
Indesit
Company
Service Manual UK
English
PROGRAMMING (Using Smartcard Reader / Card)
If the Main Module has been replaced during a repair the board will require programming using the
following method.
1.
Do NOT connect the machine to electrical supply.
2.
Insert the pre-programmed card into the Card
reader. Care must be taken at this point to ensure
the card is inserted correctly with the Chip on the
card facing the PCB of the Reader.
3.
Insert the Reader & Card into module connection
port - see photo.
4.
Connect the machine to the Electrical supply
, the
LED's on the Smart Card Reader will light in this
sequence:
a)
Red OFF: Good Communication between Smart
Card Reader & Card.
b)
Red OFF; Green Blinking: Download taking place.
c)
At end, Green ON ---> Download OK.
d)
At end, Red ON ---> Download NOT OK.
5. Programming Complete, disconnect the machine
from Electrical supply.
6. Remove the Smart Card Reader.
Smart Card Reader
and Smart Card in use
