16 of 22
Service Manual UK
Indesit
Company
English
E
Console PCB & Button Assemblies
1.
Remove the console panel (D).
2.
Remove wiring plug - taking note of position.
3.
Remove three securing clips and lift away from the console.
F
Pressure Switch
1.
Remove the table top (A).
2.
Disconnect the wiring connection block and pressure hose.
3.
Carefully unclip bracket from cabinet side and then unclip switch from bracket.
G
Door Seal & Restraint:
1.
Door Seal to Front Panel Fixing
The door seal is fixed to the cabinet front panel by a wire clamp and a small spring. The spring is
normally at the bottom of the door.
Carefully place a small screwdriver into one of the lugs of the spring and by stretching the spring
the wire band can be removed.
2.
Drum Fixing
The door seal is fixed to the drum with a zipper retainer. After removing the front panel (J) remove
the zipper retainer.
On refitting place the zipper retainer around the door seal and tighten. Observe correct seal and
zipper fixing positions.
H
Door Interlock
1.
Remove the door seal restraint (G).
2.
Peel the door seal off the front panel, and fold it back into the inner drum.
3.
Remove 2 screws from the interlock.
4.
The interlock can now be eased out, allowing access to the wiring connection block and emergency
release strap.
5.
Care must be taken to ensure the correct orientation of the wiring connection plug to prevent
seriously damaging the interlock and / or control board.
