19 of 22
Indesit
Company
Service Manual UK
English
7.
Withdraw the suspension damper. The unit should not be split and is not serviceable.
8.
When reassembling, fit a new plastic peg if the locking-tab on it shows signs of damage.
R(b) Suspension Spring
1.
Remove the table top (A).
2.
Unclip any wiring retained within the integral clip on the spring bearing keeper plate.
3.
Gently lever out the bearing keeper plate with a small flat bladed screwdriver.
4.
Unhook the spring from the cabinet top rail bearing.
S
Dispenser
1.
Remove the table top (A) and dispenser drawer (C).
2.
Remove two screws around the dispenser recess and two screws from valve support panel.
3.
Ease the dispenser backwards to unclip it from the cabinet top rail.
4.
Remove the dispenser outlet hose, and any harness retention ties.
T
Drain Pump
1.
Remove the lower rear access panel (B).
2.
Detach the sump hose from the pump using a suitable container to catch any water.
3.
Disconnect the drain hose from the pump and unplug the wiring connection block.
4.
Lift plastic the locking tab and slide the pump inwards and lift clear.
U
Inner Drum Lifter
1.
Insert a small screwdriver onto the 3rd lifter hole from the front of the drum.
This will depress the drum flap securing the lifter.
2.
Slide the lifter to the front of the drum and remove.
3.
Before refitting, lift the drum locking tab 3 mm above the drum surface.
4.
Offer the lifter to the holes in the drum, slide lifter to the back of the drum until a click is heard as
the lifter is locked into place.
V(a) Drum Assembly
1.
Remove the table top (A).
2.
Remove the top balance weight (Nb).
3.
Remove the dispenser drawer (C).
4.
Remove the console panel (D).
5.
Remove the dispenser (S).
6.
Remove the front panel (J).
7.
Remove the lower balance weight (Na).
3rd hole from the front
