�
Operation and Setup
Charger Settings > Tools
< Tools
PWM Measurement
Servo Test
·- PPM Out
� Back
In the standby interface, Long press the Okey to pop up the "Charger Settings" menu.
and then choose "Tools" item, the menu items are as follows:
PWM Measurement Test parameters such as PWM signal frequency, duty cycle and pulse width
Servo Test
Regulate the parameters of the output signal, cycle and pulse width of the RF airplane control servo
PPM Out
Control the RC airplane receiver's PPM input signal; change the signal output of those eight channels
Back
Back to the upper menu
PWM Measurement
The RC airplane control servo signal is
analyzed by the PWM protocol, the
signal output of the RC receiver is
connected, and the signal period and
pulse width of the PWM output are
automatically detected, then converted
into the steering output shaft rotation
angle value.
Servo Test
The RF airplane PWM protocol, is
directly connected to the servo;
through setting the T1 ( cycle ) and
the size of the P pulse width, it
controls the angle of the swing arm.
-
HGT;
I
H6 PRO AC/DC Smart Charger
PPM Out
PPM Out
1000
1000
1900
1500
1500
1800
1500
1000
RF airplane receiver receives the PPM
protocal, through altering signal
cycles of those 8 channels, it controls
the signal output of the receiver.