HOT TUBS Algonquin, Руководство пользователя

Страница: 23 / 40

USER MANUAL
23
Instructions
Footrest Support Installation
Skip this step if your tub does not have footrests. If you do, footrest supports
are installed in a similar manner to the seat supports. Please follow the Seat
Support instructions, below.
Bubbler Fitting Installation
(Skip this step if you did not purchase a Bubbler.)
1.
Add water to just below the hole for the Bubbler.
2.
Cut a 1 ½ inch “X” into the liner where the Bubbler hole is located.
3.
Put a generous amount of silicone on the ribbed side of the Bubbler fitting
gasket and push it through the hole.
4.
As you did with the Suction, have someone on the outside of the hot tub
thread the nut and tighten it with a wrench.
STEP 7 – Seats, Bubbler,
and Light Installation
CLICK HERE TO WATCH THE SEATS,
BUBBLER, AND LIGHT VIDEO
Important Information
• The top of the seat supports have the word “Front” written on
them. “Front” should be facing up when you install the seat
support locations are marked on the floor.
• If you have a 7-foot-diameter model, the seat support locations
are marked on the floor.
• Everything that will be installed in the hot tub should be installed
from the bottom up, starting with the footrests.