HOT TUBS Algonquin, Руководство пользователя

Страница: 12 / 40

CANADIAN HOT TUBS INC.
Instructions
Each stave has a slot cut out at the bottom that will be banged onto the outside
edge of the floor to create the wall. This slot is called a “croze.”
1.
Before you begin installing the wall, pick out the three odd-sized or smaller
staves, and set them aside. These are “spacer” staves and will be the last
ones to be installed.
STEP 2 – Stave Installation
Important Information
• Pick out the staves to be used for the front of the hot tub wall. Use
any marked or discolored staves at the back side of your hot tub.
• As you plan the arrangement of your hot tub, such as the placement
of Jets, make a mark on the floor to clearly identify where you need
to add a certain pre-cut stave.
• Suctions should be located close to the Spa Pack to minimize
plumbing.
• If you have two Suction fittings to install, space them at least
3 feet apart.
• Allow a minimum of three staves between Jets to facilitate easy
plumbing
Important Information for Hot Tubs with 10 Jets
• If your hot tub has 10 Jets, the Jet staves should be distributed to
create two separate rows of Jets – the top row about 11 inches from
the top, and the bottom row of Jets about 17 ½ inches from the top.
Be sure to leave space between the Jets to make plumbing easier.
12