HOT TUBS Algonquin, Руководство пользователя

Страница: 4 / 40

CANADIAN HOT TUBS INC.
Please follow these important safety measures when using Canadian Hot Tubs
electrical equipment. If you are not comfortable following these instructions,
consult an electrician.
1.
A green coloured terminal or a terminal marked G, GR, Ground, Grounding, or
the asterisk symbol* is located inside the supply terminal box or compartment.
To reduce the risk of electric shock, this terminal must be connected to
the grounding means provided in the electric supply service panel with a
continuous copper wire that’s the same size as the circuit conductors supplying
this equipment. * IEC 60417, Symbol 5019.
2.
At least two lugs marked “BONDING LUGS” are provided on the external
surface or on the inside of the supply terminal box or compartment. To reduce
the risk of electric shock, connect the local common bonding grid in the area
of the hot tub or spa to these terminals with an insulated or bare copper
conductor not smaller than No. 6 AWG.
3.
All field-installed metal components such as rails, ladders, drains, or other
similar hardware within 3 metres of the spa or hot tub shall be bonded to the
equipment grounding bus with copper conductors not smaller than No. 6 AWG.
4. WARNING
– To reduce the risk of injury, do not permit children to use this
product unless they are closely supervised at all times.
5.
A wire connector is provided on this unit to connect a minimum 8 AWG
(8.4 mm2) solid copper conductor between this unit and any metal equipment,
metal enclosures of electrical equipment, metal water pipe, or conduit
within 5 feet (1.5 m) of the unit.
6. DANGER
– Risk of injury – If you have been provided with a 120V
cord-connected Spa Pack
a)
Replace damaged cord immediately.
b)
Do not bury cord.
c)
Connect to a grounding type of receptacle only.
7. WARNING
– Risk of accidental drowning. Extreme caution must be exercised to
prevent unauthorized access by children. To avoid accidents, ensure that children
cannot use a spa or hot tub unless they are closely supervised at all times.
8. DANGER
– To reduce the risk of drowning from hair and body entrapment,
install a Suction fitting(s) with a marked flow rate that equals or exceeds the
flow rate marked on the equipment assembly.
4
Safety instructions for electrical equipment