HOT TUBS Algonquin, Руководство пользователя

Страница: 22 / 40

CANADIAN HOT TUBS INC.
22
Instructions
Suction Installation
1.
Add water to just below the hole(s) for the Suction. Make sure that the liner
is flat by smoothing it out with your feet.
2.
Locate the Suction hole and cut a 1 ½ inch “X” into the liner, using your foot to
hold the liner in place.
3.
Add silicone to the washer on the Suction thru-wall fitting and push it into
the hole.
4.
Have a person on the outside of the hot tub put on the nut and tighten it with
pump pliers or a pipe wrench.
5.
Once the nut has been tightened, screw the Suction screen onto the thru-wall.
6.
Repeat for the second suction, if provided.
7.
If you have two Suction fittings, the two hoses from the Suction fittings
connect to the Tee fitting that is attached to the intake (front) of the pump.
Spa Pack Installation
1.
Make sure that your Spa Pack is located within 20 feet of your hot tub and
below the water line. It will need to be accessible for maintenance.
Note:
If the Spa Pack is located less than 40 inches (1 metre) from the hot tub, you need
to protect it from getting splashed with a water shield or another type of enclosure.
2.
When the Spa Pack is in the desired location, run the white flex hose
from the Suction(s) to the front of the pump. It is recommended to dry-fit
(assemble without gluing) first. If needed, use the elbows to position the
hose into place.
3.
Once everything is together and in position, use the PVC cement to connect
the hose to the Suction fitting and the pump side of the Spa Pack. Be sure to
use PVC cement on both sides of the joints.
4.
Make sure all valves are closed before adding more water to the hot tub.
Turn the valve handles to be 90 degrees with the hose. This will turn the
flow OFF as you to proceed with the next steps.