Hospira GEMSTAR 13088-04-01, Руководство по эксплуатации системы

Страница: 139 / 161

11. GemStar® Pump Specifications
132 Hospira GemStar Manual 430-10984-001 (Rev. 03/06)
9
Open the distal slide clamp.
10
Review the program. Press to begin
review.
11
Press [
START
] to start the pump.
Stored Occlusion Volume
Delivery Rate Accuracy
The following trumpet curves represent the typical flow rate deviations, both positive
and negative, from the programmed flow rate under test conditions defined by
International Electrotechnical Commission (IEC) Standards for infusion pumps.
Using these curves, the medical professional may determine if the device can be
expected to perform in a manner suitable for the drug or fluid to be infused. The pump
sets used in this test are comparable to GemStar® Pump Set List 13273.
The typical accuracy for this device is ± 5% of the programmed rate for most
conditions, after a period of normalization. It is recommended that the medical
professional refer to the following curves when making decisions regarding drug and
fluid administration.
A single fault condition occurs when a single means for protection against a safety
hazard in equipment is defective or a single external abnormal condition is present.
The maximum over-infusion volume from a single fault condition is based upon the
calculation of the maximum time to generate an alarm times the maximum rate
possible (1000 mL/hr) as a consequence of the fault. This has been determined not to
exceed 2.78 mL.
Delivery Rate of 25
mL/hr at
Pressure Limit Stored Volume
in mL
Time to
Occlude
in seconds
Pressure Setting: Macro Micro Macro Micro Macro Micro
Low 7 psig
(48.3 kPa) 7 psig
(48.3 kPa) 0.26 0.09 50 15
Medium 14 psig
(96.5 kPa) 13 psig
(89.6 kPa) 0.54 0.14 96 23
High 32 psig
(220.6
kPa) 30 psig
(206.8
kPa) 1.24 0.40 254 83
430-10984-001.book Page 132 Friday, March 31, 2006 4:49 PM