Hospira GEMSTAR 13088-04-01, Руководство по эксплуатации системы

Страница: 110 / 161

Hospira GemStar Manual 430-10984-001 (Rev. 03/06) 103
8. Operation Test
LED Test
1
Verify that both the Power (green) and Alarm (red) LEDs are lit. Refer to
GemStar® Pump Layout on page 2 for the location of the LEDs.
2
Enter the results:
•
If both LEDs are lit, press [
YES/ENTER
].
• If either of the LEDs does not light, press [
NO
].
3
Ensure slide clamp is open prior to inserting cassette.
Volume Accuracy Test
The pump should deliver between 19.0 to 21.0 mL within approximately 3 minutes to
pass this test.
1
Load a primed pump set into the pump. Press .
2
Place the proximal end in the reservoir of water. Press .
3
Place the distal end in a 20+ mL graduated cylinder. Press .
4
Press [
START
].
5
Enter the results:
•
If the pump delivers between 19.0 to 21.0 mL, press [
YES/ENTER
].
• If the pump does not deliver between 19.0 to 21.0 mL, press [
NO
].
I
Tip: Use two microbore pump sets to save time during the next four tests. The first
set should be fully primed BEFORE beginning the volume accuracy test. Use a
second, DRY set for the air-in-line test.
When the proximal occlusion test is complete, remove the WET set from the pump
and insert the DRY set. Press [
START
] to begin the air-in-line test. The WET set can
then be placed in the next unit ready for testing.
430-10984-001.book Page 103 Friday, March 31, 2006 4:49 PM