Hoshizaki IM-240AME, Руководство по обслуживанию

Страница: 35 / 100

31 31
E1CG4880210 E1CG4880210
Fig. 15 Fig. 15
Top Panel Top Panel
Screw Screw
Unit Cover Unit Cover
If the non-rewirable plug has been cut from the power supply cord, it must be disposed of. If the non-rewirable plug has been cut from the power supply cord, it must be disposed of.
There should be no attempt to reuse it. Inserting such a plug into a socket elsewhere presents
There should be no attempt to reuse it. Inserting such a plug into a socket elsewhere presents
a serious risk of electrical shock.
a serious risk of electrical shock.
* The non-rewirable plug must never be used without a fuse cover being fitted. * The non-rewirable plug must never be used without a fuse cover being fitted.
The correct replacement for the detachable fuse cover is identifiable from the manufacturer’s The correct replacement for the detachable fuse cover is identifiable from the manufacturer’s
reference number stamped on the plug.
reference number stamped on the plug.
Supply of replacement fuse covers can be obtained from Hoshizaki Parts/Service Centres. Supply of replacement fuse covers can be obtained from Hoshizaki Parts/Service Centres.
Fuses should be rated at 13A and approved to BS 1362. Fuses should be rated at 13A and approved to BS 1362.
6. REMOTE CONDENSER UNIT (Remote Air-Cooled Model Only) 6. REMOTE CONDENSER UNIT (Remote Air-Cooled Model Only)
[a] UNPACKING [a] UNPACKING
1) Unpack and remove shipping carton, tape(s) and 1) Unpack and remove shipping carton, tape(s) and
packing. packing.
2) Remove the Top Panel. 2) Remove the Top Panel.
3) Check that the refrigerant lines do not rub or touch 3) Check that the refrigerant lines do not rub or touch
lines or other surfaces, and that the fan blade lines or other surfaces, and that the fan blade
turns freely.
turns freely.
4) Recommended parts and materials listed below 4) Recommended parts and materials listed below
will be required. will be required.
Cord Cord
17 AWG (1.0 mm 17 AWG (1.0 mm
2 2
) three-wire cord will be required for the Fan Motor wiring between ) three-wire cord will be required for the Fan Motor wiring between
the icemaker and the Condenser Unit (L+N+ ). the icemaker and the Condenser Unit (L+N+ ).
Copper Tubing Copper Tubing
Phosphorus deoxidized copper tubing. Two tubings of the same size will be required Phosphorus deoxidized copper tubing. Two tubings of the same size will be required
for refrigerant lines. Mark them for a distinction between the gas line and liquid line to
for refrigerant lines. Mark them for a distinction between the gas line and liquid line to
prevent misconnection.
prevent misconnection.
9.52 (OD) x 7.93 (ID) - Gas 9.52 (OD) x 7.93 (ID) - Gas
9.52 (OD) x 7.93 (ID) - Liquid
9.52 (OD) x 7.93 (ID) - Liquid
Pipe Insulation (for gas and liquid pipes) Pipe Insulation (for gas and liquid pipes)
To withstand temperatures up to 120°C. To withstand temperatures up to 120°C.
Bolt Bolt
Four M8 Hexagon Bolts for securing the Condenser Unit. Four M8 Hexagon Bolts for securing the Condenser Unit.
5) Do not remove the Unit Covers before finishing installation, to prevent damage to the air- 5) Do not remove the Unit Covers before finishing installation, to prevent damage to the air-
cooled Condenser. cooled Condenser.